6 STAR ENERGY RATINGS

6 star 2

What is a 6 star energy rating?

An energy rating is a calculation of the heating and cooling loads required to maintain a comfortable living environment within a given building. Factors taken into consideration include insulation, glazing, construction type, building size, orientation and climate zone.

We can provide ABSA stamped energy reports for your residential project.

FAQ

  • +

    Why do I need an energy rating for my house?

    Since May 2011, All new homes, additions and alterations in Australia are required to have a 6 star energy rating. You will be required to submit an Energy Rating Report prepared by an Accredited Assessor in order to obtain a building permit.

  • +

    At what stage is it best to get an energy rating?

    The best time is when the building plans are close to being finalised. If the design is likely to experience difficulty in achieving a 6-Star rating or you would like to obtain a higher star rating then contact us earlier in the design phase to conduct a preliminary assessment.

  • +

    How long will it take?

    We aim to have all ratings returned to you in 7 business days. This takes into account if the plans are more complex than usual. If we don't receive all the required information this will delay your energy rating.

  • +

    What do the stars mean?

    Zero stars means the building shell does practically nothing to keep out heat in summer and retain heat in winter. 6 stars indicates a good level of thermal performance, and reduced energy bills. 10 stars is the maximum, and means no artificial cooling or heating will be required to maintain a comfortable living environment year round.

  • +

    Do I need an energy rating for a renovation or extension?

    Any extension or alteration requiring a building permit also requires an energy rating. if the renovation represents less than 50% of the original volume of the building, then the house will need to be rated 6 stars, but will need to pass according to a comparative analysis assessment energy rating; more than 50% and the entire building will require a 6 star energy rating.

  • +

    What information do I need to provide?

    A complete set of plans in PDF format or hard copy (Scale 100:1 preferred), including: Site plan, floor plans, elevations, sections, and a window schedule (new & existing). Ceiling exhaust fans, downlights, and ceiling fans must also be listed or shown on plan. We can send you a checksheet to fill out to ensure we have all the required information in order to provide you an accurate energy report with a fast 24 hour turnaround.

  • +

    What if my house doesn't rate 6 stars?

    If your design doesn't initially reach the 6 star standard we will suggest some straightforward changes. Normally, we can provide a variety of alternatives which will help you achieve 6 stars or higher.

  • +

    Will it cost more to build to 6 Star?

    If the building has good design and orientation for its specific location, increased costs to reach 6 stars should be minimal. There has been much mis-information in the media regarding higher costs to achieve 6 stars - this doesn't have to be the case. The CSIRO manipulated a house plan from a very well known volume builder and achieved higher than 8 stars for only an additional $8000. Not a lot when the comfort and energy savings will more than compensate.

  • +

    What if the design options to reach 6 Star are technically difficult or cost prohibitive?

    Building surveyors can use their discretion to allow partial compliance if it is considered that reaching 6 Star would cause 'excessive hardship' (compared to the resulting benefit) or be technically not possible. E.g. An exemption may be granted if insulation were required within existing double brick walls in order to achieve 6 stars.

Back to Top